#SONIXTOUCH USER MANUAL FREE#

There is also one main board that control the data acquisition process.Internet Premium : Participation Requirements: Valid Credit Card required for bidding approval Payment Options: Visa, MasterCard, Discover, American Express, Money Order, Pay Pal, and Wire Transfer Visa MasterCard Discover American Express Payment Instructions: PLEASE EMAIL with any questions on these instructions. Inside the DAQ there are four receive board each capturing 32 channel (128 channel total). Please contact Ultrasonix in case the SonixDAQ needs maintenance or service. Maintenance and Service Дo not try to service or repair the SonixDAQ or otherwise open the casing of the device by yourself. Warning: If the equipment is used in a manner not specified by Ultrasonix, the protection provided by the equipment may be impaired. Ultrasonix cannot guarantee the proper performance of the system if used in the above listed conditions.

#SONIXTOUCH USER MANUAL FREE#

Warning: Operate in an indoor environment only, free from moisture, flammable liquids, gases, corrosive substances, strong electrical or magnetic fields, and equipment that generate high frequency waves. Note: This device is to be used only with the PSU and medical grade power supply cord provided by Ultrasonix. 5 to 122 degrees F (-15 to 50 degrees C).50 to 104 degrees F (10 to 40 degrees C).SonixDAQ Ratings and Environmental Conditions Warning: Mains supply voltage fluctuations are not to exceed 10 percent of the nominal supply voltage. Note: To disconnect the device from the power socket-outlet, unplug the DAQ's power supply from the outlet. Once powered up, three green LEDs beside the power button should turn on. After this step, the SonixDAQ is ready to be powered up by its on-off switch. Connect the power supply to the DAQ and the power outlet. Make sure the on-off switch of the DAQ is in the off state. To connect the DAQ to the power outlet, make sure that the voltage of the outlet in your area matches the specifications of the power supply provided with the DAQ. SonixRP systems are not able to provide the system clock through the BNC cable.Д¬onnecting to the Power Socket-Outlet

Note: 40MHz clock on the second BNC cable is only available on the SonixTOUCH and the SonixMDP systems. SonixDAQ generates the higher sampling frequency from this 40MHz clock. Note: Regardless of the sampling frequency of the SonixDAQ, this clock always has to 40MHz. This signal should then be connected to the DAQ through its second port using the other BNC cable. For this mode to work properly, the Sonix system should be programmed to output its internal clock to one of the BNC cable. In the external clock data acquisition mode, the DAQ will ignore its internal clock and will rely on the clock which is provided to it through the second BNC cable. To resolve this issue, the second BNC can be used to provide external clock to the DAQ. This may introduce one sample shift in-between sequences of channel data.

This clock may not be perfectly synchronized with the Sonix systems internal clock. The SonixDAQ has its own internal clock for data acquisition which is running at 40MHz. Connecting BNC Cable for Clock Signal (Optional)

Sonixtouch user manual